The Default Firewalling Guide for the Cisco EA2700

Home > Firewalls > Cisco EA2700 > Firewall Guide
EA2700

In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your router. By default the IP address should be set to 192.168.1.1.

EA2700

You should see a box prompting you for your username and password. Enter your username and password now.

The Default Router Username is: admin

The Default Router Password is: blank


Click the Ok button to log in to your router.


Default Usernames and Passwords for other Routers

Please visit our Default Router Passwords page if the username and password shown below did not work for you.

If you can't login to your router because you forgot your router username and password, use our How to Reset a Router Password guide to set your router back to its factory settings.


EA2700

Click the Security link near the top of the page.

EA2700

Put a dot into the IPv6 SPI Firewall Protection Disabled radio button.

Put a dot into the IPv4 SPI Firewall Protection Disabled radio button.

Remove the checkmark from the Filter Anonymous Internet Requests checkbox.

Remove the checkmark from the Filter Multicast checkbox.

Remove the checkmark from the Filter Internet NAT Redirection for IPv4 INternet Only checkbox.

Remove the checkmark from the Filter IDENT (Port 113) checkbox.

When you're finished, click Save Settings near the bottom of the screen to save your changes.

And that's it! You're done!


To test if your port has been properly opened, you can use our Port Checker tool.

Didn't find the screenshot you were looking for? Check our our giant collection of router screenshots.