Opening Ports for ATC Splinter Cell Pandora Tomorrow on the Dlink DSL-500T Firewall

Home > Firewalls > Dlink DSL-500T > ATC Splinter Cell Pandora Tomorrow
DSL-500T

In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your router. By default the IP address should be set to 10.1.1.1.

DSL-500T

You should see a box prompting you for your username and password. Enter your username and password now.

The Default Router Username is: admin

The Default Router Password is: admin


Click the Ok button to log in to your router.


Default Usernames and Passwords for other Routers

Please visit our Default Router Passwords page if the username and password shown below did not work for you.

If you can't login to your router because you forgot your router username and password, use our How to Reset a Router Password guide to set your router back to its factory settings.


DSL-500T

Click the Advanced button near the top of the page.

DSL-500T

Click the Filters button near the left side of the page.

DSL-500T

We will list a series of lines here that will show you exactly how to setup your router's firewall for ATC Splinter Cell Pandora Tomorrow. Go ahead and enter the settings shown below into the Filters menu and then click Apply.

Outbound Filter Inbound Filter
 
Source IP ~
Destination IP ~
Source Port ~
Destination Port ~
Protocol
Action

Put a dot into the Inbound Filter radio button.

Select Any IP from the Source IP drop down box.

Select Single IP from the Destination IP drop down box.

Enter the ip address to allow traffic to into the left Destination IP box. If you are allowing traffic so you can run a program on your computer, you should enter your computer's ip address into that box.

Select Any Port from the Source Port drop down box.

If you are opening a single port, select Single Port from the Destination Port drop down box, then enter the port number into the left Destination Port box. If you are opening a range of ports, select Port Range from the Destination Port drop down box, then enter the lowest number of the range into the left Destination Port box and the highest number of the range into the right Destination Port box.

Use the Protocol drop down box to select the protocol type of the ports you are opening.

Select Allow from the Action drop down box.

When you are finished, click the Apply button.

And that is it! You are done!


To test if your port has been properly opened, you can use our Port Checker tool.

Didn't find the screenshot you were looking for? Check our our giant collection of router screenshots.