Opening Ports for DynGate on the Sunbelt SunbeltKerioPersonalFirewall Firewall

Go ahead and open up Sunbelt Kerio Personal Firewall.

SunbeltKerioPersonalFirewall

Click the Network Security link near the left hand side of the page.

SunbeltKerioPersonalFirewall

Click the Packet Filter link near the bottom of the page.

SunbeltKerioPersonalFirewall

Click the Add button.

SunbeltKerioPersonalFirewall Click the Add button to the right of the Protocol box.SunbeltKerioPersonalFirewall

Select TCP from the Name drop down box.

Click the Ok button.

SunbeltKerioPersonalFirewall

Select UDP from the Name drop down box.

Click the Ok button.

SunbeltKerioPersonalFirewall

We will list a series of lines here that will show you exactly how to setup Sunbelt Kerio Personal Firewall's firewall for DynGate. Go ahead and enter the settings shown below into the Add Rule menu.

Click the Add button to the right of the Local box.In the menu that drops down click the Add Port option.
  Name:  
  Number:  
  Description:  

You should see another page of settings below that need to be added to Sunbelt Kerio Personal Firewall. Open up a new Add Protocol page and enter those settings.

Click the Add button to the right of the Local box.In the menu that drops down click the Add Port option.
  Name:  
  Number:  
  Description:  
Click the Add button to the right of the Local box.In the menu that drops down click the Add Port or Add Port Range option depending upon the port or ports are you trying to open.Enter the name for this rule into the Name box or boxes. It doesn't really matter what you put into those boxes. If you want, you can enter a description for this rule into the Description box or boxes. If you are opening a single port, enter that port number into the Number box. If you are opening a range of ports enter the lowest number of that range into the Number box in the First Port section.Then enter the last port of that range into the Number box of the Last Port section.

Click the Ok button.

Select the Both radio button in the Direction section. If you are allowing incoming traffic for those ports, you better allow outgoing as well.Selecting the Both option will do that. Make sure the Permit radio button has been selected in the Action section.Click the Ok button on the filters Page.

When you are finished, click the Apply button at the bottom of your screen.

And that is it! You are done!


To test if your port has been properly opened, you can use our Port Checker tool.

Didn't find the screenshot you were looking for? Check our our giant collection of router screenshots.