Port Forwarding QSee USB DVR Card on the ACorp HU5D
Before we can forward ports to your DVR, we need to change some settings in your DVR.
Open the SuperDvr program. Click the lock on the right side of the window to log in. By default the username is system and the password is blank. That might mean that you enter nothing for the password, or you might actually have to type blank.
Click the wrench tool on the right hand side of the screen to get in to the configuration menu.
The red box in the screenshot above circles the ports that must be forwarded to your computer's ip address.
To setup port forwarding on this router your computer needs to have a static ip address.
Try our free PF Setup Static IP Address Program which will setup a static ip address for your computer.
Or you can take a look at our Static IP Address guide to setup a static ip address.
When you are finished setting up a static ip address, please come back to this page and enter
the ip address you setup in the Static IP Address box below.
Do not skip this step!
Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser.
If you do not know your routers internal IP address please read our How To Find Your Routers IP Address guide.
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your router.
By default the IP address should be set to 192.168.1.1.
Click the NAT link near the center of the page.
There should be a dot in the SUA Only setting. If this isn't the case, you can not setup port forwarding without making a major change to your network. I wouldn't advise changing this unless you know what you are doing. Alright, if there is a dot in the SUA Only setting, go ahead and click Edit Details.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. QSee USB DVR Card requires you to forward the following ports: 80,1159-1161. Go ahead and enter the settings shown above into the Edit SUA/NAT Server Set menu.
| Start Port No. | End Port No. | IP Address | |
| 1 |
You should see another page of settings that need to be entered into one of the blank lines on your routers Edit SUA/NAT Server Set page. Go ahead and enter those settings now.
| Start Port No. | End Port No. | IP Address | |
| 2 |
When you're finished, click Save near the bottom of the screen to save your changes.
And that's it! You're done!
To test if your port has been properly forwarded, you can use our Port Checker tool.
Didn't find the screenshot you were looking for? Check our our giant collection of router screenshots.
