Port Forwarding CanVision on the ADDON BR4000
This guide will work for the following CanVision products.
IP-100 (Video and audio)
IP-300 (video only ip network camera)
IP-301 (Video and audio)
IP-200 (video and audio server box)
PT-300 (Pan Tilt video and audio gpio, WiFi, POE, ip network camera)
IP-560 (video and audio plus gpio plus changable lens)
MPEG4 format
IP-220 (video and audio , gpio, RS485 control video server box)
IP-580 (video and audio , gpio plus changable lens)
PT-380 (Pan Tilt video and audio , gpio, WiFi, POE, plus changable lens)
MPEG4 IP-TV
TVS-120 (IP television brocasting system)
The default port used by these cameras is TCP Port 80. You can change this port if you want to. To do so open up the O'RITE utility.
The HTTP Port1 box contains the port that should needs to be forwarded. Enter the port you chose in the following box. If you did not change port that your camera is using, just enter 80 into the following box.
O'Rite's HTTP Port1
To setup port forwarding on this router your computer needs to have a static ip address.
Try our free PF Setup Static IP Address Program which will setup a static ip address for you.
Or you can take alook at our Static IP Address guide to setup a static ip address.
When you are finished setting up a static ip address, please come back to this page and enter
the ip address you setup in the Static IP Address box below.
Do not skip this step!
Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser.
If you do not know your routers internal IP address please read our How To Find Your Routers IP Address guide.
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your router.
By default the IP address should be set to 192.168.10.1.
You should see a box prompting you for your username and password. Enter your username and password now.
By default the username is admin, and the password is 1234. Click the Ok button to log in to your router.
Please visit our Default Router Passwords page if the username and password shown above did not work for you.
Click the NAT link near the top of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. CanVision requires you to forward the following ports: 100000. Go ahead and enter the settings shown above into the Virtual Server menu.
| Private IP | Private Port | Type | Public Port | Comment | Enabled | |
| 1. | 192.168.10. |
When you're finished, click OK near the bottom of the screen to save your changes.
And that's it! You're done!
To test if your port has been properly forwarded, you can use our Port Checker tool.
Didn't find the screenshot you were looking for? Check our our giant collection of router screenshots.
