Port Forwarding QSee QSDR168GRTC-500 on the Actiontec GT701R

What is Port Forwarding?

View all Router Screenshots.

Home > Routers > Actiontec > GT701R > QSee QSDR168GRTC-500

Configuring the DVR to pick up an IP address

  • Press Menu
  • Select Network
  • Make sure Type is set to DHCP

  • Select Apply
  • Select Exit
The DVR will reboot & pick up an ip address from the router.


Identifying the IP address

  • Press Menu
  • Select Network
  • Write down the ip address, subnet mask & gateway.


Assign a Static IP

  • Change Type to Static
  • Input the same ip address, subnet mask & gateway - (you wrote down earlier).

  • Select Apply
  • Select Exit
Now you have completed the ip configuration for the dvr.
Move on to the port forwarding section . in you router.

To setup port forwarding on this router your computer needs to have a static ip address.
Try our free PF Setup Static IP Address Program which will setup a static ip address for your computer.

Or you can take a look at our Static IP Address guide to setup a static ip address. When you are finished setting up a static ip address, please come back to this page and enter the ip address you setup in the Static IP Address box below.

Do not skip this step!

GT701R

Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser. If you do not know your routers internal IP address please read our How To Find Your Routers IP Address guide.

In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your router. By default the IP address should be set to 192.168.0.1.

GT701R

Click the Setup / Configuration link.

GT701R

Click the Advanced Setup link near the left of the page.

GT701R

Click the Begin Advanced Setup button.

GT701R

Click the Port Forward link near the left of the page.

GT701R


Entry #1

We will list a series of lines here that will show you exactly how to forward the ports you need to forward. QSee QSDR168GRTC-500 requires you to forward the 80,9000 ports. Go ahead and enter the settings shown above into the Port Forwarding menu and then click Add.

IP Port Range Protocol IP Address
to



Entry #2

You should see another page of settings that need to be entered into one of the blank lines on your routers Port Forwarding page. Go ahead and enter those settings and then click Add.

IP Port Range Protocol IP Address
to

When you're finished, click Save and Restart near the left of the screen to save your changes.

And that's it! You're done!


To test if your port has been properly forwarded, you can use our Port Checker tool.

Didn't find the screenshot you were looking for? Check our our giant collection of router screenshots.