Before we can forward ports for ActiveWebCam, we need to figure out what ports ActiveWebCam++ is using. Here is a brief walkthrough on how to do that. Go ahead and open up ActiveWebCam and get into the camera you want to modifies settings.

At the top of the camera's properties page click the Broadcasting link.

There are two things on this page that require forwarding a port. If you have Remote Access enabled, you need to forward the port in the remote accesses section's Port box. You can change the port that is in that box if you like. Please enter the port for Remote Access into the box below. If you are not using Remote Access just leave this box blank.

Open a web browser like internet explorer or Netscape. Enter the ip address of your router in the address bar of your browser. In the picture above the address bar has http://www.google.com in it. Just replace all of that with the ip address of your router. By default the ip address should be set to 192.168.0.1.

Click the Advanced link near the left side of the page.

You should now see a new menu. In this new menu, click Virtual Servers.

We will list a series of lines here that will show you exactly how to forward the ports you need to forward. Active Webcam requires you to forward the ports you entered above. Go ahead and enter the settings shown above into the Virtual Servers menu and then click Add as New Server.

You should see another page of settings that need to be entered into one of the blank lines on your routers Virtual Servers page. Go ahead and enter those settings and then click Add as New Server.

And that is it! You are done!