Port Forwarding XBOX360 Bionic Commando Rearmed on the Allied Telesyn AR240E
To setup port forwarding on this router your computer needs to have a static ip address.
Try our free PF Setup Static IP Address Program which will setup a static ip address for your computer.
Or you can take a look at our Static IP Address guide to setup a static ip address.
When you are finished setting up a static ip address, please come back to this page and enter
the ip address you setup in the Static IP Address box below.
Do not skip this step!
Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser.
If you do not know your routers internal IP address please read our How To Find Your Routers IP Address guide.
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your router.
By default the IP address should be set to 192.168.1.1:8080.
You should see a box prompting you for your username and password. Enter your username and password now.
By default the username is manager, and the password is friend. Click the Ok button to log in to your router.
Please visit our Default Router Passwords page if the username and password shown above did not work for you.
Click the Security link near the left of the page.
Click the NAT link.
If NAT is not enabled, you do not have to do port forwarding. Your router is setup as a bridge. You get your IP addresses directly from your ISP.
If the software you are trying to run does not work, your ISP may be blocking those ports. You should make sure those ports are allowed through
any firewall you may have on your computer.
If NAT is enabled, you should see a Add Reserved Mapping button on this page. Go ahead and click that button now.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. XBOX360 Bionic Commando Rearmed requires you to forward the 3074 ports. Go ahead and enter the settings shown above into the Reserved Mapping Configuration menu and then click Apply.
| Add Reverse Address Mapping on Interface PPPoE | |||
| Global IP Address | Internal IP Address | Protocol | Port Number |
You should see another page of settings that need to be entered into one of the blank lines on your routers Reserved Mapping Configuration page. Go ahead and enter those settings and then click Apply.
| Add Reverse Address Mapping on Interface PPPoE | |||
| Global IP Address | Internal IP Address | Protocol | Port Number |
When you're finished, click Save Configuration near the left of the screen to save your changes.
And that's it! You're done!
To test if your port has been properly forwarded, you can use our Port Checker tool.
Didn't find the screenshot you were looking for? Check our our giant collection of router screenshots.
