To setup port forwarding on the Aztech DSL600ER router your device needs to have a static IP address. You should complete one of the following steps first:
Now that you have setup a Static IP Address on your device, please enter the IP address that you assigned to your device here:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Aztech DSL600ER router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Aztech DSL600ER router. By default the IP address should be set to 192.168.1.254.
You should see a box prompting you for your username and password. Enter your username and password now.
Click the Ok button to log in to your Aztech DSL600ER router.
Please visit our Default Aztech Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Aztech DSL600ER router username and password, use our How to Reset a Router Password guide to set your Aztech DSL600ER router back to its factory settings.
Configuring the DVR to pick up an IP address
Identifying the IP address
Assign a Static IP
Move on to the port forwarding section . in you router.
Now that you are logged in to your Aztech DSL600ER router you should see the following:
Click the Advanced button near the top of the page.
Click the Application link near the left of the page.
The menu on the left should change. In this new menu, click Port Forwarding.
Put a dot into the User radio button.
Click the New button near the bottom of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. QSee QSDR44DRTC requires you to forward the 80,9000 ports. Go ahead and enter the settings shown above into the Rule Management menu and then click Apply.
|Port Start||Port End|
You should see another page of settings that need to be entered into one of the blank lines on your routers Rule Management page. Go ahead and enter those settings and then click Apply.
|Port Start||Port End|
Select the applications you just created in the Available Rules list, then click the Add > button to move them to the Applied Rules box.
When you are finished, click the Apply button.
And that is it! You are done!
Now that you have forwarded ports for QSee QSDR44DRTC on the Aztech DSL600ER you should test to see if your ports are forwarded correctly.