If you don't know what Port Forwarding is yet, you might want to start by reading our What is Port Forwarding guide.
You might also be interested in our huge collection of Router Screenshots where you can see every page of every router that we know of.[an error occurred while processing this directive]
To setup port forwarding on the Beam GW410 router your device needs to have a static IP address. You should complete one of the following steps first:
Now that you have setup a Static IP Address on your device, please enter the IP address that you assigned to your device here:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Beam GW410 router's internal IP address. You can find it by doing one of the following:
Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser.
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Beam GW410 router. By default the IP address should be set to 192.168.1.1.
We do not currently know the default username and password for your router. If you know them, please use our Comments page to let us know what they are. Thanks!Please visit our Default Router Passwords page if the username and password shown above do not work for you.
If you are having trouble with this guide, then perhaps PFConfig may be your solution. PFConfig is a software tool that will automatically forward ports for your Beam GW410 router to save you time and hassle.
Before we can forward ports, we need to do a little configuration. Here is a brief walkthrough on how to do that. Go ahead and open up your thermostat's Configuration page.
On this page you need to change the HTTP Port to 81, and ASCII Port to 10001. For every additional thermostat you'll want to increase each number by one. So thermostat #1 would be ports 81 and 10001, thermostat #2 would be ports 82 and 10002, thermostat #3 would be ports 83 and 10003, ect.
Once you've finished configuring things, go ahead and click the Save & Reboot button to save things. After you have finished saving and rebooting, you will need to log in to your thermostat again.
Now that you are logged in to your Beam GW410 router you should see the following:
Click the Firewall link near the top of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. Network Thermostat UP32-WIFI requires you to forward the 81,10001 ports. Go ahead and enter the settings shown above into the Port Forwarding menu and then click Add.
You should see another page of settings that need to be entered into one of the blank lines on your routers Port Forwarding page. Go ahead and enter those settings and then click Add.
And that is it! You are done!
Now that you have forwarded ports for Network Thermostat UP32-WIFI on the Beam GW410 you should test to see if your ports are forwarded correctly.