To setup port forwarding on the Cisco Linksys-E1000 router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Cisco Linksys-E1000 router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Cisco Linksys-E1000 router. By default the IP address should be set to 192.168.1.1.
You should see a box prompting you for your username and password. Enter your username and password now.
Click the Ok button to log in to your Cisco Linksys-E1000 router.
Please visit our Default Cisco Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Cisco Linksys-E1000 router username and password, use our How to Reset a Router Password guide to set your Cisco Linksys-E1000 router back to its factory settings.
Now that you are logged in to your Cisco Linksys-E1000 router you should see the following:
Click the Applications & Gaming link near the top of the page.
This router has two different sections that allow you to forward ports. One section allows you to forward a range of ports, and the other allows you to forward a single port. To forward a range of ports, click Port Range Forwarding. To forward a single port, click Single Port Forwarding.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. Panasonic BL-C230A requires you to forward the following ports: 80. Go ahead and enter the settings shown above into the Single Port Forwarding or Port Range Forwarding menu.
|Single Port Forwarding|
When you're finished, click Save Settings near the bottom of the screen to save your changes.
And that's it! You're done!
Now that you have forwarded ports for Panasonic BL-C230A on the Cisco Linksys-E1000 you should test to see if your ports are forwarded correctly.