Free Port Forwarding Guides & PFConfig: Forward Your Ports Automatically
The Default Port Forwarding Guide for the Comtrend CT-562
To setup port forwarding on this router your computer needs to have a static ip address.
Try our free PF Setup Static IP Address Program which will setup a static ip address for your computer.
Or you can take a look at our Static IP Address guide to setup a static ip address.
When you are finished setting up a static ip address, please come back to this page and enter
the ip address you setup in the Static IP Address box below.
Do not skip this step!
Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser.
If you do not know your routers internal IP address please read our How To Find Your Routers IP Address guide.
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your router.
By default the IP address should be set to 192.168.1.1.
You should see a box prompting you for your username and password. Enter your username and password now.
By default the username is root, and the password is 12345. Click the Ok button to log in to your router.
Please visit our Default Router Passwords page if the username and password shown above did not work for you.
Click the NAT link near the left of the page.
Click the Port Range Mapping link near the top of the page.
Click the Add button near the bottom of the page.
Put a dot into the NAT Interface radio button.
If you are forwarding a single port, enter that port number into the Public Port From, Public Port To, Local Port From and Local Port To boxes. If you are forwarding a range of ports, enter the lowest number of the range into the Public Port From and Local Port From boxes. Then enter the highest number of the range into the Public Port To and Local Port To boxes.
Enter the ip address to forward these ports to into the Local Address box. If you are forwarding ports so you can run a program on your computer, you should enter your computer's ip address into that box.
Use the Protocol drop down box to select the protocol type of the ports you are forwarding.
When you are finished, click the Apply button.
And that is it! You are done!
To test if your port has been properly forwarded, you can use our Port Checker tool.
Didn't find the screenshot you were looking for? Check our our giant collection of router screenshots.