Free Help Setting up Your Router or Firewall Set up your router from home
Router List Port List Port Checker Other Guides Game Guides Store Support Forum
see list of routers and firewalls below

Default Port Forwarding on the Encore ENDSL-AR4


What is Port Forwarding?
What is Port Triggering?


To setup port forwarding on this router your computer needs to have a static ip address. Take a look at our Static IP Address guide to setup a static ip address. When you are finished setting up a static ip address, please come back to this page and enter the ip address you setup in the Static IP Address box below.

Do not skip this step!




Open a web browser like internet explorer or Netscape. Enter the ip address of your router in the address bar of your browser. In the picture above the address bar has http://www.google.com in it. Just replace all of that with the ip address of your router. By default the ip address should be set to 10.0.0.2.




You should see a box prompting you for your username and password. Enter your username and password now. By default the username is admin, and the password is conexant. Click the Ok button to log in to your router.

Please visit our default username and passsword page, if the username and password shown above did not work for you.




Click the Virtual Server link near the left of the page.




Enter a number that has not yet been used into the ID box. If you are forwarding a single port, enter that port number into the Public Port - Start, Private Port and the Public Port - End boxes. If you are forwarding a range of ports, enter the lowest number of that range into the Public Port - Start, Private Port box. Then enter the highest number of that range into the Public Port - End box. Select the protocol type using the Port Type radio button. If you need both TCP and UDP, create a duplicate configuration. The first configuration would have TCP selected, while the second one would have UDP selected. Enter the ip address to forward these ports to into the Host IP Address box. If you are forwarding ports so you can run a program on your computer, you should enter your computer's ip address into that box. When you are finished, click the Add This Setting button.

When you're finished, click Save Settings / Reboot near the left of the screen to save your changes.

And that's it! You're done!



To test if your port has been properly forwarded, you can use our Port Checker tool.