Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Level One FBR-1416A router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Level One FBR-1416A router. By default the IP address should be set to 192.168.0.1.
You should see a box prompting you for your username and password. Enter your username and password now.
Click the Ok button to log in to your Level One FBR-1416A router.
Please visit our Default Level One Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Level One FBR-1416A router username and password, use our How to Reset a Router Password guide to set your Level One FBR-1416A router back to its factory settings.
This guide will work for the following CanVision products.
IP-100 (Video and audio)
IP-300 (video only ip network camera)
IP-301 (Video and audio)
IP-200 (video and audio server box)
PT-300 (Pan Tilt video and audio gpio, WiFi, POE, ip network camera)
IP-560 (video and audio plus gpio plus changable lens)
IP-220 (video and audio , gpio, RS485 control video server box)
IP-580 (video and audio , gpio plus changable lens)
PT-380 (Pan Tilt video and audio , gpio, WiFi, POE, plus changable lens)
TVS-120 (IP television brocasting system)
The default port used by these cameras is TCP Port 80. You can change this port if you want to. To do so open up the O'RITE utility.
The HTTP Port1 box contains the port that should needs to be forwarded. Enter the port you chose in the following box. If you did not change port that your camera is using, just enter 80 into the following box.
Now that you are logged in to your Level One FBR-1416A router you should see the following:
Click the Advanced link near the left of the page.
Click the Virtual Servers link near the center of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. CanVision requires you to forward the ports you entered above. Go ahead and enter the settings shown above into the Virtual Servers menu and then click Add.
|Internal Port No.||External Port No.|
And that is it! You are done!
Now that you have forwarded ports for CanVision on the Level One FBR-1416A you should test to see if your ports are forwarded correctly.