To setup port forwarding on the Net-Lynx WR514R router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Net-Lynx WR514R router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Net-Lynx WR514R router. By default the IP address should be set to 192.168.1.1.
You should see a box prompting you for your username and password. Enter your username and password now.
Click the Ok button to log in to your Net-Lynx WR514R router.
Please visit our Default Net-Lynx Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Net-Lynx WR514R router username and password, use our How to Reset a Router Password guide to set your Net-Lynx WR514R router back to its factory settings.
Now that you are logged in to your Net-Lynx WR514R router you should see the following:
Click the Firewall link near the left of the page.
You should now see a new menu. In this new menu, click Port Forwarding.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. Prey requires you to forward the 27719 ports. Go ahead and enter the settings shown above into the Port Forwarding menu and then click Apply Changes.
|Enable Port Forwarding|
|IP Address:||Protocol:||Port Range: -||Comment:|
And that is it! You are done!
Now that you have forwarded ports for Prey on the Net-Lynx WR514R you should test to see if your ports are forwarded correctly.