To setup port forwarding on the Netgear WGT624v3 router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Netgear WGT624v3 router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Netgear WGT624v3 router. By default the IP address should be set to 192.168.1.1.
You should see a box prompting you for your username and password. Enter your username and password now.
Click the Ok button to log in to your Netgear WGT624v3 router.
Please visit our Default Netgear Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Netgear WGT624v3 router username and password, use our How to Reset a Router Password guide to set your Netgear WGT624v3 router back to its factory settings.
Now that you are logged in to your Netgear WGT624v3 router you should see the following:
Click the Port Forwarding / Port Triggering link near the left of the page.
Put a dot into the Port Forwarding radio button.
Click the Add Custom Service button.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. Remote Desktop requires you to forward the 3389 ports. Go ahead and enter the settings shown above into the Custom Services menu and then click Apply.
|Server IP Address||...|
And that is it! You are done!
Now that you have forwarded ports for Remote Desktop on the Netgear WGT624v3 you should test to see if your ports are forwarded correctly.