To setup port forwarding on the Netgear WNDR3300 router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Netgear WNDR3300 router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Netgear WNDR3300 router. By default the IP address should be set to 192.168.1.1.
You should see a box prompting you for your username and password. Enter your username and password now.
Click the Ok button to log in to your Netgear WNDR3300 router.
Please visit our Default Netgear Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Netgear WNDR3300 router username and password, use our How to Reset a Router Password guide to set your Netgear WNDR3300 router back to its factory settings.
Now that you are logged in to your Netgear WNDR3300 router you should see the following:
Click the Port Forwarding / Port Triggering link near the left of the page.
Put a dot into the Port Forwarding radio button.
Click the Add Custom Service button near the bottom of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. XBOX360 Command and Conquer Red Alert 3 requires you to forward the 3074 ports. Go ahead and enter the settings shown above into the Port Forwarding menu and then click Apply.
|Server IP Address|
And that is it! You are done!
Now that you have forwarded ports for XBOX360 Command and Conquer Red Alert 3 on the Netgear WNDR3300 you should test to see if your ports are forwarded correctly.