To setup port forwarding on the Netopia 3346N-002 router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Netopia 3346N-002 router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Netopia 3346N-002 router. By default the IP address should be set to 192.168.1.1.
Click the Ok button to log in to your Netopia 3346N-002 router.
Please visit our Default Netopia Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Netopia 3346N-002 router username and password, use our How to Reset a Router Password guide to set your Netopia 3346N-002 router back to its factory settings.
Now that you are logged in to your Netopia 3346N-002 router you should see the following:
Click the Expert Mode link near the left of the page.
Click the Yes, enter expert mode button near the center of the page.
The menu on the left should change. In this new menu, click Configure.
You should now see a new menu. In this new menu, click NAT.
Click the Define Custom Service button near the center of the page.
Put a dot into the Port Forwarding: Range of Ports radio button.
Click the Next button.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. EVE Online requires you to forward the 26000 ports. Go ahead and enter the settings shown above into the Port Range menu and then click Next.
|The above name will be saved as this service's description|
|Global Port Range:||-|
|Base Host Port:|
Select the service you created from the Service Name drop down box.
Click the Enable button.
And that is it! You are done!
Now that you have forwarded ports for EVE Online on the Netopia 3346N-002 you should test to see if your ports are forwarded correctly.