To setup port forwarding on the New Link 93071G router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your New Link 93071G router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your New Link 93071G router. By default the IP address should be set to 192.168.1.1.
Click the Log In button to log in to your New Link 93071G router.
Please visit our Default New Link Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your New Link 93071G router username and password, use our How to Reset a Router Password guide to set your New Link 93071G router back to its factory settings.
If you are having trouble with this guide, then perhaps PFConfig may be your solution. PFConfig is a software tool that will automatically forward ports for your New Link 93071G router to save you time and hassle.
Before we can forward ports for BearShare, we need to figure out what ports BearShare is using. Here is a brief walkthrough on how to do that. Go ahead and open up BearShare.
Click Setup in the menu at the top of your screen. In the list that drops down click Connection.
On this page you should see a Listening Port for Incomming TCP and UDP Connections box. This box contains the port you need to forward to the computer you are running BearShare on. You can change this port number if you want to. Please enter the port you chose into the box below.
Now that you are logged in to your New Link 93071G router you should see the following:
Click the Advanced button near the top of the page.
The menu on the left should change. In this new menu, click Port Forwarding.
Put a dot into the User radio button.
Click the New button near the bottom of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. BearShare requires you to forward the ports you entered above. Go ahead and enter the settings shown above into the Rule Management menu and then click Apply.
|Port Start:||Port End:|
When you're finished, click Save All near the left of the screen to save your changes.
And that's it! You're done!
Now that you have forwarded ports for BearShare on the New Link 93071G you should test to see if your ports are forwarded correctly.