To setup port forwarding on the Open Networks iConnectAccess624W3.6 router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Open Networks iConnectAccess624W3.6 router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Open Networks iConnectAccess624W3.6 router. By default the IP address should be set to 192.168.1.254.
You should see a box prompting you for your username and password. Enter your username and password now.
Click the Ok button to log in to your Open Networks iConnectAccess624W3.6 router.
Please visit our Default Open Networks Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Open Networks iConnectAccess624W3.6 router username and password, use our How to Reset a Router Password guide to set your Open Networks iConnectAccess624W3.6 router back to its factory settings.
If you are having trouble with this guide, then perhaps PFConfig may be your solution. PFConfig is a software tool that will automatically forward ports for your Open Networks iConnectAccess624W3.6 router to save you time and hassle.
This guide will work for the following CanVision products.
IP-100 (Video and audio)
IP-300 (video only ip network camera)
IP-301 (Video and audio)
IP-200 (video and audio server box)
PT-300 (Pan Tilt video and audio gpio, WiFi, POE, ip network camera)
IP-560 (video and audio plus gpio plus changable lens)
IP-220 (video and audio , gpio, RS485 control video server box)
IP-580 (video and audio , gpio plus changable lens)
PT-380 (Pan Tilt video and audio , gpio, WiFi, POE, plus changable lens)
TVS-120 (IP television brocasting system)
The default port used by these cameras is TCP Port 80. You can change this port if you want to. To do so open up the O'RITE utility.
The HTTP Port1 box contains the port that should needs to be forwarded. Enter the port you chose in the following box. If you did not change port that your camera is using, just enter 80 into the following box.
Now that you are logged in to your Open Networks iConnectAccess624W3.6 router you should see the following:
Click the Advanced button near the top of the page.
The menu on the left should change. In this new menu, click Port Forwarding.
Put a dot into the User radio button.
Click the New button near the bottom of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. CanVision requires you to forward the AppFullPortsListTag ports. Go ahead and enter the settings shown above into the Rule Management menu and then click Apply.
You should see another page of settings that need to be entered into one of the blank lines on your routers Rule Management page. Go ahead and enter those settings and then click Apply.
Select the applications you just created in the Available Rules list, then click the Add > button to move them to the Applied Rules box.
When you are finished, click the Apply button.
When you're finished, click Save All Settings near the left of the screen to save your changes.
And that's it! You're done!
Now that you have forwarded ports for CanVision on the Open Networks iConnectAccess624W3.6 you should test to see if your ports are forwarded correctly.