To setup port forwarding on the Ovislink WT-2000ARM router your device needs to have a static IP address. You should complete one of the following steps first:
Now that you have setup a Static IP Address on your device, please enter the IP address that you assigned to your device here:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Ovislink WT-2000ARM router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Ovislink WT-2000ARM router. By default the IP address should be set to 192.168.2.1.
You should see a box prompting you for your username and password. Enter your username and password now.
Click the Ok button to log in to your Ovislink WT-2000ARM router.
Please visit our Default Ovislink Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Ovislink WT-2000ARM router username and password, use our How to Reset a Router Password guide to set your Ovislink WT-2000ARM router back to its factory settings.
Now that you are logged in to your Ovislink WT-2000ARM router you should see the following:
Click the Advanced Setup link near the top of the page.
Click the NAT link near the top of the page.
Click the Virtual Server link near the bottom of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. Warp Pipe requires you to forward the 4000 ports. Go ahead and enter the settings shown above into the Virtual Server menu and then click Save.
|Rule Index :|
|Start Port Number :|
|End Port Number :|
|Local IP Address :|
And that is it! You are done!
Now that you have forwarded ports for Warp Pipe on the Ovislink WT-2000ARM you should test to see if your ports are forwarded correctly.