To setup port forwarding on the Prolink WGR1004 router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Prolink WGR1004 router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Prolink WGR1004 router. By default the IP address should be set to 192.168.1.254.
We do not currently know the default username and password for your router. If you know them, please use our Comments page to let us know what they are. Thanks!Please visit our Default Router Passwords page if the username and password shown above do not work for you.
Now that you are logged in to your Prolink WGR1004 router you should see the following:
Click the Advanced link near the left of the page.
You should now see a new menu. In this new menu, click Virtual Servers.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. DNS2Go requires you to forward the 1227 ports. Go ahead and enter the settings shown above into the Virtual Servers menu and then click Save.
|Enable Virtual Servers|
|Local IP Address:|
And that is it! You are done!
Now that you have forwarded ports for DNS2Go on the Prolink WGR1004 you should test to see if your ports are forwarded correctly.