To setup port forwarding on the Q-Tec 790RH router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Q-Tec 790RH router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Q-Tec 790RH router. By default the IP address should be set to 192.168.1.1.
Click the Ok button to log in to your Q-Tec 790RH router.
Please visit our Default Q-Tec Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Q-Tec 790RH router username and password, use our How to Reset a Router Password guide to set your Q-Tec 790RH router back to its factory settings.
If you are having trouble with this guide, then perhaps PFConfig may be your solution. PFConfig is a software tool that will automatically forward ports for your Q-Tec 790RH router to save you time and hassle.
Now that you are logged in to your Q-Tec 790RH router you should see the following:
Click the Advanced Setup link near the center of the page.
Click the NAT link near the left of the page.
Click the Virtual Server link near the left of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. TeamSpeak 3 Server requires you to forward the following ports: 9987,10011,30033. Go ahead and enter the settings shown above into the Virtual Server menu.
|Mapping Ports||Server IP||Enabled|
When you're finished, click Apply near the bottom of the screen to save your changes.
And that's it! You're done!
Now that you have forwarded ports for TeamSpeak 3 Server on the Q-Tec 790RH you should test to see if your ports are forwarded correctly.