To setup port forwarding on the Repotec RP-WR1440A router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Repotec RP-WR1440A router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Repotec RP-WR1440A router. By default the IP address should be set to 192.168.1.1.
You should see a box prompting you for your username and password. Enter your username and password now.
Click the Ok button to log in to your Repotec RP-WR1440A router.
Please visit our Default Repotec Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Repotec RP-WR1440A router username and password, use our How to Reset a Router Password guide to set your Repotec RP-WR1440A router back to its factory settings.
Now that you are logged in to your Repotec RP-WR1440A router you should see the following:
Click the Firewall link near the left of the page.
You should now see a new menu. In this new menu, click Port Forwarding.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. iCamSource requires you to forward the 12000-12100 ports. Go ahead and enter the settings shown above into the Port Forwarding menu and then click Apply Changes.
|Enable Port Forwarding|
|Local IP Address:||Protocol:||Port Range: -|
And that is it! You are done!
Now that you have forwarded ports for iCamSource on the Repotec RP-WR1440A you should test to see if your ports are forwarded correctly.