To setup port forwarding on the Sitecom WL-018 router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Sitecom WL-018 router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Sitecom WL-018 router. By default the IP address should be set to 192.168.123.254.
You should see a box prompting you for your Sitecom WL-018 password. Enter the password now.
Click the Log in button to log in to your Sitecom WL-018 router.
Please visit our Default Sitecom Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Sitecom WL-018 router password, use our How to Reset a Router Password guide to set your Sitecom WL-018 router back to its factory settings.
Now that you are logged in to your Sitecom WL-018 router you should see the following:
Click the Forwarding Rules link near the left of the page.
You should now see a new menu. In this new menu, click Virtual Server.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. EvoCam requires you to forward the following ports: 8080. Go ahead and enter the settings shown above into the Virtual Server menu.
|ID||Service Ports||Server IP||Enable|
When you're finished, click Save near the bottom of the screen to save your changes.
And that's it! You're done!
Now that you have forwarded ports for EvoCam on the Sitecom WL-018 you should test to see if your ports are forwarded correctly.