Login To The Sitecom WL-122 Router Using Your Web Browser
Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser.
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Sitecom WL-122 router.
By default the IP address should be set to 192.168.1.254.
You should see a box prompting you for your username and password. Enter your username and password now.
The Default Sitecom WL-122 Router Username is: blank
The Default Sitecom WL-122 Router Password is: sitecom
Click the Ok button to log in to your Sitecom WL-122 router.
Default Usernames and Passwords for other Sitecom Routers
If you can't login to your router because you forgot your Sitecom WL-122 router username and password, use our
How to Reset a Router Password guide to set your
Sitecom WL-122 router back to its factory settings.
How to Port Forward QSee QT4 QT52X DVRs on the Sitecom WL-122
Having trouble forwarding ports on the Sitecom WL-122?
If you are having trouble with this guide, then perhaps PFConfig may be your solution.
PFConfig is a software tool that will automatically forward ports for your router to save you time and hassle.
Go to the Network Menu.
Put a check into the Obtain an IP Address Automatically box.
Click the Test button.
Look near the lower left corner. If it says Ok, then click on Apply, then Exit.
Go to Menu - Information and Network
Write down the IP Address, Subnet Mask and Gateway.
Go back to the Network Menu.
Uncheck the Obtain an IP Address Automatically box.
Now enter the IP Address, Gateway and Subnet Mask you wrote down earlier.
When you're done click Apply, then Exit.
Sitecom WL-122 Router Port Forwarding Screenshots
Now that you are logged in to your Sitecom WL-122 router you should see the following:
Click the Setup link near the left of the page.
You should now see a new menu. In this new menu, click Advanced.
Click the Add button near the center of the page.
Forward Ports 80 on the Sitecom WL-122
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. QSee QT4 QT52X DVRs requires
you to forward the 80,6036 ports. Go ahead and enter the settings shown above into the Add Port Forwarding Rule menu and then click Ok.
Forward Ports 6036 on the Sitecom WL-122
You should see another page of settings that need to be entered into one of the blank lines on your routers Add Port Forwarding Rule page.
Go ahead and enter those settings and then click Ok.
And that is it! You are done!
Test if Your Ports are Open
Now that you have forwarded ports for QSee QT4 QT52X DVRs on the Sitecom WL-122 you should test to see if your ports are forwarded correctly.
To test if your port has been properly forwarded, you can use our Open Port Check tool.
Our Open Port Check tool is the only online port checking tool with Guaranteed Results.