Login To The Sitecom WL-183 Router Using Your Web Browser
Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser.
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Sitecom WL-183 router.
By default the IP address should be set to 192.168.0.1.
You should see a box prompting you for your username and password. Enter your username and password now.
The Default Sitecom WL-183 Router Username is: admin
The Default Sitecom WL-183 Router Password is: admin
Click the Ok button to log in to your Sitecom WL-183 router.
Default Usernames and Passwords for other Sitecom Routers
If you can't login to your router because you forgot your Sitecom WL-183 router username and password, use our
How to Reset a Router Password guide to set your
Sitecom WL-183 router back to its factory settings.
How to Port Forward QSee QSD2304L on the Sitecom WL-183
Having trouble forwarding ports on the Sitecom WL-183?
If you are having trouble with this guide, then perhaps PFConfig may be your solution.
PFConfig is a software tool that will automatically forward ports for your router to save you time and hassle.
Configuring the DVR to pick up an IP address
Put a check in the DHCP box.
Exit out to the live cameras by pressing the ESC button on the DVR.
Power Cycle the DVR
Remove the power cable from the back of the dvr.
Wait 20 seconds.
Plug in the power cable.
Identifying the IP address
Write down the IP address, subnet mask & gateway found on your info network screen.
Assign a Static IP
Remove the check from the DHCP box.
Input the same IP address, subnet mask & gateway - (you wrote down earlier).
Sitecom WL-183 Router Port Forwarding Screenshots
Now that you are logged in to your Sitecom WL-183 router you should see the following:
Click the Advanced Settings link near the top of the page.
Click the Port fw. link near the top of the page.
Forward Ports 80 on the Sitecom WL-183
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. QSee QSD2304L requires
you to forward the 80,2000 ports. Go ahead and enter the settings shown above into the Port fw. menu and then click Add.
Enable Port Forwarding
Forward Ports 2000 on the Sitecom WL-183
You should see another page of settings that need to be entered into one of the blank lines on your routers Port fw. page.
Go ahead and enter those settings and then click Add.
Enable Port Forwarding
And that is it! You are done!
Test if Your Ports are Open
Now that you have forwarded ports for QSee QSD2304L on the Sitecom WL-183 you should test to see if your ports are forwarded correctly.
To test if your port has been properly forwarded, you can use our Open Port Check tool.
Our Open Port Check tool is the only online port checking tool with Guaranteed Results.