To setup port forwarding on the Solwise SAR-600EW router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Solwise SAR-600EW router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Solwise SAR-600EW router. By default the IP address should be set to 192.168.1.1.
You should see a box prompting you for your username and password. Enter your username and password now.
Click the Ok button to log in to your Solwise SAR-600EW router.
Please visit our Default Solwise Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your Solwise SAR-600EW router username and password, use our How to Reset a Router Password guide to set your Solwise SAR-600EW router back to its factory settings.
Now that you are logged in to your Solwise SAR-600EW router you should see the following:
Click the Advanced button near the top of the page.
The menu on the left should change. In this new menu, click Port Forwarding.
Put a dot into the User radio button.
Click the New button.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. GeoVision CenterV2 requires you to forward the 5546-5549 ports. Go ahead and enter the settings shown above into the Rule Management menu and then click Apply.
|Rule Name :|
|Port Start :||Port End :|
|Port Map :|
Select the applications you just created in the Available Rules list, then click the Add > button to move them to the Applied Rules box.
When you are finished, click the Apply button.
And that is it! You are done!
Now that you have forwarded ports for GeoVision CenterV2 on the Solwise SAR-600EW you should test to see if your ports are forwarded correctly.