To setup port forwarding on the US Robotics USR8011 router your computer needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your US Robotics USR8011 router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your US Robotics USR8011 router. By default the IP address should be set to 192.168.123.254.
You should see a box prompting you for your US Robotics USR8011 password. Enter the password now.
Click the Log in button to log in to your US Robotics USR8011 router.
Please visit our Default US Robotics Router Passwords page if the username and password shown below did not work for you.
If you can't login to your router because you forgot your US Robotics USR8011 router password, use our How to Reset a Router Password guide to set your US Robotics USR8011 router back to its factory settings.
If you are having trouble with this guide, then perhaps PFConfig may be your solution. PFConfig is a software tool that will automatically forward ports for your US Robotics USR8011 router to save you time and hassle.
Configuring the DVR to pick up an IP address
Power Cycle the DVR
Identifying the IP address
Assign a Static IP
Now that you are logged in to your US Robotics USR8011 router you should see the following:
Click the Virtual Server link near the left of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. Qsee QSTD501616C-500 requires you to forward the following ports: 80,2000. Go ahead and enter the settings shown above into the Virtual Server menu.
|ID||Service Ports||Server IP||Enable|
When you're finished, click Save near the bottom of the screen to save your changes.
And that's it! You're done!
Now that you have forwarded ports for Qsee QSTD501616C-500 on the US Robotics USR8011 you should test to see if your ports are forwarded correctly.