To setup port forwarding on the Virata DSL906EU-WebCom router your device needs to have a static IP address. You should complete one of the following steps first:
Now we need to know your routers IP address. You can find it a variety of ways.
It's ok if you don't know your Virata DSL906EU-WebCom router's internal IP address. You can find it by doing one of the following:
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your Virata DSL906EU-WebCom router. By default the IP address should be set to 192.168.1.1.
We do not currently know the default username and password for your router. If you know them, please use our Comments page to let us know what they are. Thanks!Please visit our Default Router Passwords page if the username and password shown above do not work for you.
First we need to make sure that your DVR is configured correctly. In the KGuard menu system you should see the following.|
Go ahead and select Setup.
Now select Network
Make sure Net Type is set to Static IP, then make a note of the IP Address listed here. In the picture above the IP Address is listed as 192.168.3.106. Yours will be different. Write down the numbers that you see on your DVR. This is the address that you'll be forwarding the ports to.
Now that you are logged in to your Virata DSL906EU-WebCom router you should see the following:
Click the NAT inbound link near the left of the page.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. KGuard KG-SH122E requires you to forward the 67,68,80 ports. Go ahead and enter the settings shown above into the NAT inboundrule menu and then click Create.
When you're finished, click Save config near the left of the screen to save your changes.
And that's it! You're done!
Now that you have forwarded ports for KGuard KG-SH122E on the Virata DSL906EU-WebCom you should test to see if your ports are forwarded correctly.