This guide allows you to use our Port Trigger application along with the port triggering section of your router to forward ports.
Open up the Port Trigger application, and click New button to configure a new rule.
Put a name of the program you are forwarding ports for in to the Application Name box. It doesn't really matter what you put into this box, but something that will remind you why this configuration is here would be a good idea. Click the Autoset button to get an external ip address. Alternatively you can enter any ip address that is outside of your network, in to the Target Address box. Enter the trigger port to use into the Trigger Port box. Once again it doesn't really matter what port you use here. You can pick any random port to put into the Trigger Port box, or just leave at it's default setting. Select the protocol to use by clicking the UDP/TCP radio buttons. Once again it doesn't really matter what protocol you select, but you do need to remember which one you chose. Later on in this guide, we will be entering the selections you chose here into your router. The Delay box tells the Port Trigger application how often to send the packets. If you have problems, like the ports not being forwarded all the time, you should decrease the number in the delay box.
I need you to fill in the boxes below, with the values you entered into the Port Trigger application. Entering the requested values will allow this guide to show you exactly how to configure your router.
Since you are reading this guide, I'm going to assume that you have Bit Tornado installed. Open up Bit Tornado.
Close to the top you will see a Prefs link. Go ahead and click that link now.
The Port Range box defines the ports that Bit Tornado will use. These are the ports that you need to forward to your computer. Bit Tornado does not need the full 50,000 ports that come predefined. Go ahead and uncheck the Random checkbox. Enter 10000 into the From box, and enter 10010 into the To box. If you expect to download more than 10 files at the same time, then you should make this range of ports larger.
On this page there is a UPNP Port Forwarding drop down box. Open it up and set that box to disabled. We are not going to use UPNP to forward our ports. Now go find your router on our routers page, and forward the port range you set above.
Open a web browser like internet explorer or Netscape.
Enter the ip address of your router in the address bar of your browser. In the picture above the address bar has http://www.google.com in it. Just replace all of that with the ip address of your router. By default the ip address should be set to 192.168.0.1.
You should prompted for your password. Enter your password now. By default the password is admin. Click the Ok button to log in to your router.
The next screen that appears is the Main Menu. Click Advanced at the bottom of the screen.
The next screen that appears is the Advanced Menu. Click Special AP at the bottom of the screen.
We will list a series of lines here that will show you exactly how to configure port triggering. BitTornado requires you to forward the 10000-10010 ports. Go ahead and enter the settings shown above into the Applications menu.
Then click the Apply button at the bottom of the page to save your settings. Thats it! You are done!
