Free Port Forwarding Guides & PFConfig: Forward Your Ports Automatically

Configuring the Port Trigger Application

This guide allows you to use our Port Trigger application along with the port triggering section of your router to forward ports.

Open up the Port Trigger application, and click New button to configure a new rule.

Put a name of the program you are forwarding ports for in to the Application Name box. It doesn't really matter what you put into this box, but something that will remind you why this configuration is here would be a good idea. Click the Autoset button to get an external ip address. Alternatively you can enter any ip address that is outside of your network, in to the Target Address box. Enter the trigger port to use into the Trigger Port box. Once again it doesn't really matter what port you use here. You can pick any random port to put into the Trigger Port box, or just leave at it's default setting. Select the protocol to use by clicking the UDP/TCP radio buttons. Once again it doesn't really matter what protocol you select, but you do need to remember which one you chose. Later on in this guide, we will be entering the selections you chose here into your router. The Delay box tells the Port Trigger application how often to send the packets. If you have problems, like the ports not being forwarded all the time, you should decrease the number in the delay box.

I need you to fill in the boxes below, with the values you entered into the Port Trigger application. Entering the requested values will allow this guide to show you exactly how to configure your router.

Configuring your Router to work with Port Trigger.

Before we can forward ports for eMule, we need to figure out what ports eMule is using. Here is a brief walkthrough on how to do that. Go ahead and open up eMule.

Click the Options button in the menu at the top of your screen.

Click the Connection option on the left hand side of your screen. You should see a TCP box and an UDP box. Enter a random port into each of these boxes. It doesn't matter what ports you choose, but a port numbers between 10000 and 60000 would be a good idea. A higher numbered port is generally the best to use, because most ISP's do not block the higher numbered ports. Please enter the port you chose for the TCP box into the box below.

Please enter the port you chose for the UDP box into the box below.

Open a web browser like internet explorer or Netscape.

Enter the ip address of your router in the address bar of your browser. In the picture above the address bar has http://www.google.com in it. Just replace all of that with the ip address of your router. By default the ip address should be set to 192.168.0.1.

You should see a box prompting you for your username and password. Enter your username and password now. By default the username is blank, and the password is admin. Click the Ok button to log in to your router.

Click Advanced in the menu at the top of the screen. This should change this menu on the left. Click Port Triggers in this new menu.

We will list a series of lines here that will show you exactly how to configure your router. eMule requires you to forward the ports you entered above. Go ahead and enter the settings shown above into the Port Triggers menu.

You should see another page of settings that need to be entered into one of the blank lines on your router's Port Triggers page. Go ahead and enter those settings now.

When you are finished, click the Apply button near the bottom of the screen.

And that's it! You're done!