Setting up a secure wireless network with the AirLink+ RTW026.

View all Router Screenshots.

Home > Wifi Routers > AirLink+ > RTW026 > Wireless Security

In the picture above the address bar has in it. Just replace all of that with the internal IP address of your AirLink+ router. By default the IP address should be set to

You should see a box prompting you for your AirLink+ password. Enter the password now.

The Default AirLink+ Router Password is: admin

Click the Ok button to log in to your AirLink+ router.

Default Usernames and Passwords for other AirLink+ Routers

Please visit our Default AirLink+ Router Passwords page if the username and password shown below did not work for you.

If you can't login to your router because you forgot your AirLink+ router password, use our How to Reset a Router Password guide to set your AirLink+ router back to its factory settings.

Click the Wireless link near the left side of the page.

In the box called Wireless SSID put a name that you make up. You will need to remember this name because it will be used to connect to your wireless network. Do not make it obvious to guess, the network name should be difficult for your neighbors to guess. If you can not think of anything, simply use your first name.

In the box called Channel, pick a random channel number. Channels make it so that you and your neighbors can use your own wireless networks without interfering with each other. By picking a random channel you reduce the chance of your neighbor using the same channel as you.

Click the Configure WEP button.

Put a dot into the 128 bits radio button.

Put a dot into the Open radio button.

Put a dot into the Hexadecimal radio button.

Put a dot into the WEP Key 1 radio button.

Now you need to make up your network key. It doesn't matter what this key is, as long as it is random. A network key is a password that is 26 characters long, and made up of only the letters A,B,C,D,E,F and the numbers 0,1,2,3,4,5,6,7,8,9. If you are using 128 bit WEP, then your key must be exactly 26 characters long, and the more random it is, the better it is. Here is an example of a random 128 bit network key:

Once you have made up your key, write it down somewhere. You will need it at each device that you are going to connect to your network.

Now put the key you made up in the box called WEP Key 1.

When you are finished, click the Apply button.

When you're finished, click Apply near the bottom of the screen to save your changes.

And that's it! You're done!

Connecting to your Secure Wireless Network

You may want to read our guide on how to Configure Windows XP to connect to your wireless network.