Port Forwarding Warez on the 2wire 2700hg
Before we can forward ports for Warez, we need to figure out what ports Warez is using. Here is a brief walkthrough on how to do that. Go ahead and open up Warez.
Click Main in the menu at the top of your screen. In the list that drops down click Preferences.
On the left side of this page click on Network. Now we need to what port is in use
for Warez under the option "Listen port". It doesn't really matter what port you choose, but a port between
9000 and 60000 would be a good idea. These higher numbered ports are rarely blocked by ISPs.
Once you have chosen a port (9000 is the default for Warez) please enter that port number into
the box to the right of the Network settings box. That port should also be put into the Listen port box.
I also need to you enter that port number into the box below.
Warez's port for incoming TCP connections
Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser.
If you do not know your routers internal IP address please read our How To Find Your Routers IP Address guide.
In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your router.
By default the IP address should be set to 172.16.0.1.
Click the Firewall button.
Click the Firewall Settings button.
Use the Select a computer box to choose a computer to forward ports to. This box contains a list of computer names that are visible on your network.
Click the Add a new user-defined application link.
We will list a series of lines here that will show you exactly how to forward the ports you need to forward. Warez requires you to forward the ports you entered above. Go ahead and enter the settings shown above into the Edit Application menu and then click Add Definition.
 | |||||
| Application Name: | |||||
 | |||||
| Protocol: | TCP | UDP | |||
| Port (or Range): | From: | To: | |||
| Protocol Timeout (seconds): | TCP default=86400 UDP default=600 | ||||
| Map to Host Port: | Default= the same port as defined above | ||||
 | |||||
You should see another page of settings that need to be entered into one of the blank lines on your routers Edit Application page. Go ahead and enter those settings and then click Add Definition.
| |||||
| Application Name: | |||||
| |||||
| Protocol: | TCP | UDP | |||
| Port (or Range): | From: | To: | |||
| Protocol Timeout (seconds): | TCP default=86400 UDP default=600 | ||||
| Map to Host Port: | Default= the same port as defined above | ||||
| |||||
Click the Back button.
Select the applications you just created in the Applications list, then click the Add button to move them to the Hosted Applications box.
When you are finished, click the Done button at the bottom of your screen.
And that is it! You are done!
To test if your port has been properly forwarded, you can use our Port Checker tool.
Didn't find the screenshot you were looking for? Check our our giant collection of router screenshots.
