Port Forwarding WarezP2P on the 2wire 2700HG-D

What is Port Forwarding?

View all Router Screenshots.

Before we can forward ports for WarezP2P, we need to figure out what port WarezP2P is using. Here is a brief walkthrough on how to do that. Go ahead and open up WarezP2P.

Click Tools in the menu at the top of your screen. In the list that drops down click Options.

In the menu at the left hand side of your screen double click the Advanced option. Clicking Advanced, should drop down a couple more options. In this new list of options click the Firewall Config option. Put a dot into the Manual Port Forward radio button. The port you need to forward is in the box to the right of the Manual Port Forward text. You can change this port if you want to. Just keep in mind that whatever port is in the Manual Port Forward box, should also be in the Listen On Port box. Then click the Apply button at the bottom of the page.

Please enter the number that was in the Manual Port Forward box into the box below.

Open a web browser like Internet Explorer or Firefox. Enter the internal IP address of your router in the address bar of your browser. If you do not know your routers internal IP address please read our How To Find Your Routers IP Address guide.

In the picture above the address bar has http://www.google.com in it. Just replace all of that with the internal IP address of your router. By default the IP address should be set to 172.16.0.1.

Click the Firewall button.

Click the Firewall Settings button.

Use the Select a computer box to choose a computer to forward ports to. This box contains a list of computer names that are visible on your network.

Click the Add a new user-defined application link.

We will list a series of lines here that will show you exactly how to forward the ports you need to forward. WarezP2P requires you to forward the ports you entered above. Go ahead and enter the settings shown above into the Edit Application menu and then click Add Definition.

	Application Name:
	Protocol:	TCP		UDP
	Port (or Range):	From:		To:
	Protocol Timeout (seconds):			TCP default=86400 UDP default=600
	Map to Host Port:			Default= the same port as defined above

You should see another page of settings that need to be entered into one of the blank lines on your routers Edit Application page. Go ahead and enter those settings and then click Add Definition.

	Application Name:
	Protocol:	TCP		UDP
	Port (or Range):	From:		To:
	Protocol Timeout (seconds):			TCP default=86400 UDP default=600
	Map to Host Port:			Default= the same port as defined above

Click the Back button.

Select the applications you just created in the Applications list, then click the Add button to move them to the Hosted Applications box.

When you are finished, click the Done button at the bottom of your screen.

And that is it! You are done!

To test if your port has been properly forwarded, you can use our Port Checker tool.

Didn't find the screenshot you were looking for? Check our our giant collection of router screenshots.